SA

VIC

You are currently viewing our Victoria website.
STORE

Systems

Best Sellers

CALCULATORS
PRODUCT INFO

Pedestrian Slat Gates

Sliding Slat Gates

Gate Panel Calculator

Click here to go to our Fence Calculator

You can use our calculator below to figure out all the materials you need for a gate panel.
This calculator takes the make size for your gate and allows you to either order just the materials, a gate kit (materials cut to size), or a full gate fabrication (ready for install).

Single Gate:
Measure your opening width, if installing posts, deduct the size of the post you are using (50mm each side for our 12G posts), then deduct an additional 40mm (20mm gap each side).
Then decide how tall you want your gate to be, and then deduct 50mm for the gap underneath.
Example:
Opening Width is 1200 -> Make Width is 1200-50-50-40 = 1060.
Finish Height is 1800 -> Make Height is 1800-50 = 1750.


Double Gate:
Measure your opening width, if installing posts, deduct the size of the post you are using (50mm each side for our 12G posts), then deduct an additional 60mm (20mm gap each side and in-between).
Then decide how tall you want your gates to be, and then deduct 50mm for the gap underneath.
Example:
Opening Width is 2000 -> Make Width is 2000-50-50-60 = 1840/2 = 920 per gate.
Finish Height is 1800 -> Make Height is 1800-50 = 1750.

When measuring your opening, take into account whether or not you will be installing new posts or using existing posts.
If installing new posts, measure from the outside of where the new posts will be installed. For example, if you are going to mount a post against a wall, measure from the wall and then deduct the width of the post.
If you already have posts installed, measure from inside the posts, and only deduct the gaps needed.

Add Hardware:
By ticking ‘Add Hardware’ the calculator will take into account the size of the gate, and whether it is single or double, and provide the necessary locks, hinges, etc.

Add Posts:
By ticking ‘Add Posts’ the calculator will allow for our 12G posts to be concreted into the ground. This adds 600mm to be installed into the ground.
If you will not be concreting posts, feel free to untick this option and manually add posts to your cart afterwards.

Light Duty

Best for: Small Entry Gates, Low Use Personnel Access Gates, DIY Friendly

Max Size: 1800h x 900w

Hardware: LokkLatch Deluxe & TruClose Regular Hinges

Medium Duty

Best for: High Traffic Personnel Access, High Strength Access, Architectural Areas

Max Size: 2200h x 1250w

Hardware: LokkLatch Deluxe & TruClose Heavy Duty Hinges

Heavy Duty

Best for: Driveway Gates, Caravan Parking Areas, High Wind Load Areas

Max Size: 2200h x 1800w

Hardware: LokkLatch Deluxe & SureClose Non Self-Close Hinges

Single or Double Gate?

Height

Width

Pick your Slat:
Enter Gap Size:
Pick your Edge Colour:
Pick your Slat Colour:

Gate Render

(Click and hold to rotate, scroll to zoom, right-click and hold to move)

Indicative Purposes Only.

Average Lead Times – Kit Form (1 – 2 weeks) | Gate Fabrication ( 2 – 4 weeks)